1 Burn incense on coals Traditionally Incense was burnt on coals . You need to a refractory vessel and possibly some sand . Nowadays, the most popular type of coal is the self-ignition of coal. It is simple to use, because they are - once lit - durchzündet itself . But here you should make sure that the coal gets around enough air during the ignition process . It is better to put the round tablet upright (especially when we burned incense on sand ) , so she can get enough air through the ignition. Once gray spots are visible at the edges of the coal, you can return it umkippen.Nun Räucherspaß the start . First Dose careful because both resins and herbs with the smoke volume can be tremendous. Then there are also the pure Japanese coal. It is a pure pressed charcoal without any additives . It is a little harder to get going, but they smolder first , it works just like the self-ignition of coal. Burn time is approximately 1 hour for both coals. A third possibility is the pure nature - Charcoal . Here is pressed herbs that even produce a pleasant scent. The herbs coal smolder smolder slowly through the resin piece by piece lying on it. So who the effect of black carbon is too hard , you can try with the much gentler herbs coal. Is to smoke the herb coal to a power vessel , where they will find more air to get Durchglimmen than on sand is best. 2 Smoking on a wire The other type of smoking is the smoking over a tealight candle with a sieve. This method is based on aromatherapy. A very fine mesh being placed at a distance of about 5 to 10 cm above a tea light . For this, aroma lamps , of which you remove the shell and replace it with an Incense or manufactured specifically for the screens are Räucherstövchen . The herbs or resins are added directly to the screen . Due to the rising heat of the candle flame be extinguished them slowly . Caution: If the power gets too close to the candle , to herbs or resins are flammable . Please do not leave unattended !
Show 1 to 7 (from a total of 7 products)